Planning law
How to read a German zoning plan: symbols, use template, building envelope
On a coloured German development plan (Bebauungsplan) drawn to the federal symbols ordinance, the blue line is the building limit, the red line the building line, and “WA II 0,4” means general residential area, at most two full storeys, site coverage ratio 0.4. On 600 m² of building land, GRZ 0.4 gives 240 m² of footprint under planning law; section 19(4) BauNVO sets what garages and drives may add (up to 360 m² in the example), and state building rules also apply.
On this page
The parts of a development plan
A development plan is a municipal bylaw (section 10(1) Building Code, BauGB): a drawing, a written part where there is one, and a statement of reasons. The drawing sits on a base map meant to show the parcels and their numbers as in the land survey register (section 1(2) PlanZV).
On a phone, swipe the table sideways to see every column.
| Part | What it contains | What to look for |
|---|---|---|
| Drawing (Planzeichnung) | Zones, lines, areas and use templates | The boundary of the plan area, a grey line (annex no. 15.13 PlanZV, section 9(7) BauGB) |
| Legend (Zeichenerklärung) | The meaning of every symbol used | How this plan uses each symbol |
| Written rules (textliche Festsetzungen) | Rules that cannot be drawn, such as uses that are excluded | Binding together with the drawing |
| Notes and adopted rules (Hinweise, nachrichtliche Übernahmen) | Rules from other laws, such as listed monuments under state law (section 9(6) BauGB) | Meant to be labelled as such (section 2(1) PlanZV) |
| Statement of reasons (Begründung) | Aims and effects; the environmental report is a separate part (section 2a BauGB) | Why a rule reads as it does |
A parcel outside the plan boundary is not covered by it. Where plans are online is shown in the comparison of state geoportals. The municipality must let anyone inspect the plan and its reasons and explain its content on request (section 10(3) BauGB).
The use template, field by field
The use template is the small grid of letters and numbers in the zones of the drawing. The fields rest on section 9(1) nos. 1 and 2 BauGB and the Land Use Ordinance (Baunutzungsverordnung, BauNVO).
- Type of usegeneral residential area; what may be built there is set by section 4 BauNVO
- Full storeysat most two; what counts as a full storey is defined by state law (section 20(1) BauNVO)
- Site coverage ratio (GRZ)number without a circle: 0.4 m² of footprint per m² of plot (section 19 BauNVO)
- Floor area ratio (GFZ)number in a circle: 0.8 m² of floor area per m² of plot (section 20 BauNVO)
- Building patternopen, with side clearance to the boundaries (section 22(2) BauNVO)
- Roofpitched roof with slope; a local design rule under state law (section 9(4) BauGB)
Source: Editorial schematic with example values, based on the PlanZV annex nos. 1–3, sections 16, 19, 20 and 22 BauNVO and the town of Bruchsal, 12 November 2026
On a phone, swipe the table sideways to see every column.
| Field | Example | Meaning | Legal basis |
|---|---|---|---|
| Type of use | WA, MI, GE | Zone type; sections 2 to 14 BauNVO become part of the plan unless it departs from them under section 1(4) to (10) | section 1(3) BauNVO |
| Full storeys (Vollgeschosse) | II, III-V, II in a circle | Roman numeral = maximum; with a hyphen, minimum and maximum; in a circle, mandatory | Annex no. 2.7 PlanZV, section 16(4) BauNVO |
| Site coverage ratio (GRZ) | 0,4 or GRZ 0,4 | Share of the plot that buildings and structures may cover; GR 100 m² states a fixed area instead | Nos. 2.5 and 2.6, section 19 BauNVO |
| Floor area ratio (GFZ) | 0,8 in a circle or GFZ 0,8 | Floor area of all full storeys per m² of plot; GF 500 m² states a fixed area | Nos. 2.1 and 2.2, section 20 BauNVO |
| Building pattern (Bauweise) | o, g, a | Open, closed (no side clearance) or as the plan defines; own symbols for detached, semi-detached or terraced houses only | Nos. 3.1 to 3.3, section 22 BauNVO |
| Height | TH, FH, OK, WH | Eaves, ridge, top or wall height above a stated reference point | No. 2.8, section 18 BauNVO |
German plans use a decimal comma: 0,4 means 0.4. What counts as a full storey depends on your state’s building code (section 20(1) BauNVO), hence “II = max. 2 VG nach LBO” in the town of Bruchsal’s reading guide.
A plan that regulates the scale of building must always set the GRZ or a fixed footprint (section 16(3) BauNVO). A template without a GFZ is not incomplete: scale may be controlled through storeys or heights.
Plan symbols and colours
The annex to the PlanZV gives each kind of content a symbol and, for coloured plans, a colour. Municipalities may add or adapt symbols (section 2(2) PlanZV), and older plans and their amendments may keep the pre-1981 and pre-1990 symbols (section 3 PlanZV).
On a phone, swipe the table sideways to see every column.
| Symbol on the plan | Colour under the PlanZV | Meaning | Annex no. |
|---|---|---|---|
| Area marked WA | Medium red | General residential area (allgemeines Wohngebiet) | 1.1.3 |
| Area marked MI | Medium brown | Mixed area (Mischgebiet) | 1.2.3 |
| Area marked GE | Medium grey | Commercial area (Gewerbegebiet) | 1.3.1 |
| Line | Red | Building line (Baulinie) | 3.4 |
| Line | Blue | Building limit (Baugrenze) | 3.5 |
| Area | Gold ochre | Public road (Straßenverkehrsfläche) | 6.1 |
| Line | Light permanent green | Street boundary line (Straßenbegrenzungslinie); omitted where it coincides with a building line or limit | 6.2 |
| Outline with St or Ga | Red | Area for parking spaces (Stellplätze) or garages (Garagen) | 15.3 |
| Area | see the plan legend | Area to be burdened with rights of way and utility rights (Geh-, Fahr- und Leitungsrechte) | 15.5 |
| Line | Dark grey | Boundary of the plan area | 15.13 |
Such an area on your plot is a planning rule. It does not prove that a private right of way has been created; check that in an extract from the land register (Grundbuch).
Building limit, building line and building envelope
The area where the main building may stand is called the building envelope (Baufenster), in law the buildable part of the plot, set by building lines, building limits or a building depth (section 23(1) BauNVO).
Source: Editorial schematic based on sections 19 and 23 BauNVO and PlanZV annex nos. 3.4, 3.5 and 6.2, 12 November 2026
- Building line (red): the house must be built on it. A minor step forward or back of parts of the building may be allowed, and the plan may provide further exceptions.
- Building limit (blue): buildings and parts of buildings may not cross it. A minor projection may be allowed.
- Building depth: measured from the actual edge of the street, unless the plan says otherwise (section 23(4)).
- Outside the envelope, ancillary structures (section 14 BauNVO) and structures state law allows within clearances may be permitted unless the plan rules them out (section 23(5)).
Envelope and GRZ apply side by side: if the envelope fits only 200 m², that is the limit even where the GRZ allows more. State clearance rules (Abstandsflächen) apply on top; see the comparison of setback rules.
Height, roof and ridge direction
Heights appear as TH (eaves height), FH (ridge height) or OK (top edge), each in metres above a reference point such as “über Gehweg” (above the pavement) or “über NN” (above sea level), annex no. 2.8. The plan must state the reference points (section 18(1) BauNVO); on a slope, 9 m above the pavement is not 9 m above the ground.
Roof shape and pitch are not in the BauNVO. They rest on state law, which section 9(4) BauGB lets states bring into the plan; Bruchsal adopts them as local design rules (örtliche Bauvorschriften) in a separate part. A line or arrow in the envelope may fix the ridge direction, based on the positioning of buildings (section 9(1) no. 2 BauGB); the legend says what it means.
Worked example: 600 m² with GRZ 0.4 and GFZ 0.8
Take a parcel of 600 m², all of it building land behind the street boundary line; only that land counts (section 19(3) BauNVO). The template reads WA, II, GRZ 0.4, GFZ 0.8.
- Footprint: 600 m² × 0.4 = 240 m². That is what structures may cover (section 19(2)).
- Garages, drives, ancillary structures: they count, but may take the footprint up by 50% to 360 m² (ratio 0.6); the 0.8 cap (480 m²) is not reached.
- Floor area: 600 m² × 0.8 = 480 m², outside measurements of all full storeys (section 20(3)); two storeys of 240 m² use it up exactly.
Source: Own calculation under sections 19 and 20 BauNVO, example values, 12 November 2026
The plan may set a different rule to the 50%, such as a lower limit (section 19(4) sentence 3 BauNVO), and further minor excesses may be allowed. Unless the plan provides otherwise, the authority may waive the limits in an individual case if the excess has only a minor effect on the natural functions of the soil, or if keeping to them would make it substantially harder to use the plot for its purpose. For covered parking spaces and garages, section 21a(3) BauNVO has its own rule, which applies only as far as section 19(4) does not stand in the way.
Balconies, loggias, terraces, ancillary structures and structures that state law allows within the clearances are left out of the floor area (section 20(4)). Habitable rooms in an attic that is not a full storey count only if the plan says so (section 20(3) sentence 2). The calculation follows the current BauNVO. Older plans may be governed by an earlier version; section 25c BauNVO, for instance, applies the earlier text to drafts put on public display before 27 January 1990. Ask the municipality which version your plan uses.
Written rules and notes
The written part may list uses that are allowed only by exception or excluded (section 1(4) to (10) BauNVO). Read it in full before concluding from “WA” what may be built; if drawing and text seem to differ, ask the municipality.
Notes and adopted rules come from other laws, such as monument or nature protection, and apply under those laws. Under planning law, a project within a qualified plan is allowed if it does not contradict the plan and access and services are secured (section 30(1) BauGB); building regulations and other laws apply as well (section 29(2) BauGB).
Reading your plan in six steps
- Locate the parcel. Check it lies inside the plan boundary; its number is on the cadastral map.
- Note the date and amendments. Ask the municipality for the publication date and any later amending plans.
- Read the zone and template. Watch for lines separating zones or different scales within one zone (annex no. 15.14).
- Measure the envelope. Use the dimensions on the lines or scale them off.
- Read the text and notes. Exclusions, height references, roof rules, planting duties.
- Ask open questions in writing. The planning office (Bauamt) tells you about any fee and reply time.
Whether your own project would be allowed, and how to get a binding answer before you buy, is covered in zoning and buildability check.
How it looks in the report
For the Brühl-Badorf sample parcel, the register read lists no development plan. The page says so and names the next step: request the plan and its reasons from the town of Brühl, including plans not online.

The report does not decode a use template.
Checklist to print
- □ Parcel lies inside the plan boundary
- □ Latest version, all amending plans and the legend obtained
- □ Zone, full storeys, GRZ, GFZ and building pattern noted from the template
- □ Footprint worked out (building land × GRZ) and the extra for garages and drives checked against section 19(4) BauNVO
- □ Envelope compared with the intended layout
- □ Heights with reference point, roof rules, written rules and notes read
- □ Open questions sent to the municipality in writing
For a single parcel, the report shows whether the state register lists a development plan, along with flood areas, standard land value and other data where the state publishes them. Gaps are marked. It does not include the land register (Grundbuch) or the register of building encumbrances (Baulastenverzeichnis). Check a property before you buy.
Editorial team: GrundCheck. Checked: 12 November 2026.
Official sources, accessed 12 November 2026
- Plan Symbols Ordinance (PlanZV), section 1: base maps
- PlanZV section 2: plan symbols
- PlanZV section 3: transition
- Annex to the PlanZV: symbols for land-use plans
- Section 1 BauNVO: zones
- Section 16 BauNVO: scale of building
- Section 18 BauNVO: height
- Section 19 BauNVO: site coverage ratio and footprint
- Section 20 BauNVO: full storeys, floor area ratio
- Section 21a BauNVO: parking and garages
- Section 14 BauNVO: ancillary structures
- Section 22 BauNVO: building pattern
- Section 23 BauNVO: buildable area
- Section 25c BauNVO: transition
- Section 2a BauGB: statement of reasons and environmental report
- Section 9 BauGB: content of the development plan
- Section 10 BauGB: adoption, publication, inspection
- Section 29 BauGB
- Section 30 BauGB
- Town of Bruchsal: how to read a development plan (PDF, German)